Just remember the main steps are:
1. Downgrade the SPL to at or below 3.xxx (which is required to install XSPL)
2. Install XSPL (RSPL/HSPL)
3. Flash a custom rom of your choice.
I would recommend to follow step by step tutorial here -
disclaimer. i hold no responsiblity for one's actions and the result of one's device because of those actions.
1. Downgrade the SPL to at or below 3.xxx (which is required to install XSPL)
2. Install XSPL (RSPL/HSPL)
3. Flash a custom rom of your choice.
I would recommend to follow step by step tutorial here -
Begin Here
- find out device's Bootloader version. Settings -> About -> More Info
- make sure device's battery is greater than 60% before proceeding.
- download task 00 and task 29, here and extract contents.
- note. USB drivers may need install. e.g. Active Sync / Windows Mobile Device Center
- continue to next Step according to Bootloader version...instructions to downgrade OSPL
if Bootloader version is 5.xx - a. for those with a Pre-Mango Zune Backup,
- see Zubair Kirmani's thread, here.
b. for Europe devices,
- see ansar.ath.gr's thread, here.
c. for everybody else,
- try Y-Cable method here
- or Goldcard method here.
if Bootloader version is 4.xx - download non-Test NoDo or Pre-NoDo Radio specific to your device, here.
- extract the contents of the 7-zip.
- turn off device. then while pressing the volume down button, boot your device.
- device should be in Multi-Colored screen, which says 'Serial' in the white section.
- connect device via USB to PC
- device should now say 'USB' in the white section.
- in the 'stock' folder of the extracted Radio, flash SPL_Signed.nbh using task 00.
- note. this will also downgrade the Radio, as well as the SPL.
- once flash successfully finishes, disconnect device from USB.
- repeat Steps #1, #2 & #5.instructions to install RSPL
if Bootloader version is 3.xx or 2.xx or 1.xx - download XSPL, here.
- extract the contents of the rar.
- run DFT_RSPL..._LAUNCH.exe
- please, read information text. select 'Next' button.
- power off device and enter Bootloader.
- connect device via USB to PC, 'Serial' will change to 'USB' once connected properly.
- select 'Next' button on the XSPL wizard and it should now detect your device.
- note. do not proceed if OSPL is 5.xx or 4.xx, instead go to Step 05.
- select the closest OSPL, on the wizard, to the one on device.
- select 'Next' button. wait until wizard proceeds to final page. read and close window.
- note. device must boot into Bootloader.
- if Bootloader reads RSPLX.Y.Z and CotullaRSPL, then RSPL was successful.
- continue to Step #30 or #38.instructions to install HSPL
if RSPL'd and HSPL is desired - make sure RSPL wizard is closed.
- run DFT_HSPL..._INSTALL.exe
- please, read information text. select 'Next' button.
- device should already be RSPL'd and connected to PC, still.
- select 'Next' button. wizard should detect your device.
- select HSPL, then select 'Next' button. wait until wizard proceeds to final page.
- read and close window, then disconnect device from USB.
- enter Bootloader on device, if it reads HSPLX.Y.Z and CotullaHSPL, then flash was successful.instructions to install a Shipped or Custom ROM
if a different OS is desired - download ROM of choice. Shipped ROMs are available, here.
- extract RUU_Signed.nbh (if Shipped ROM) or RUU_Unsigned.nbh (if Custom ROM).
- note. flashing a RUU_Signed.nbh will also replace device's R/HSPL to OSPL of ROM.
- bring device into Bootloader and connect to PC via USB.
- flash extracted *.nbh using task29.
- once flash successfully finishes, disconnect device from USB.
- enjoy new ROM.instructions to install a Radio
if a different Radio is desired - download the Radio of choice, here.
- extract the contents of the 7-zip.
- boot device into Bootloader and connect to PC via USB.
- flash RUU_Unsigned.nbh from 7-zip with task00.
- after flash successfully finishes, disconnect device from USB.
- enjoy new Radio.
disclaimer. i hold no responsiblity for one's actions and the result of one's device because of those actions.
i guess this tut is for pros....i am a complete novice.... can u help me from the scratch ?
ReplyDeletego ahead ........ i am sure you can do it .......... cuz i had installed it on my htc hd 7 @ first try (8gb) (europe) rom .......if not i m here to help you ...
ReplyDelete